OIL PRESSURE RELIEF VALVE

Pressure relief are designed to provide protection from over- in steam, gas, air and liquid lines. Water and back regulators is the same device, only differing in application. The water "lets off steam" when safe s are exceeded, then closes again when drops to a preset level. A back regulator maintains upstream at the desired setting by opening to allow excess upstream to flow downstream. The temperature is self-operating that is installed in a process system to protect against over pressurization of the system. The thermal designed to continuously regulate fluid flow, and to keep from exceeding a preset value. There are a wide variety of designs, but most resemble diaphragm s, globe s, or swing check s. With many of these designs, a helical or hydraulic spring is used to maintain constant force acting on the backside of the disk or diaphragm, causing the to be normally closed. When the force exerted by the process stream (i.e. fluid ) on the disk is greater than the constant force exerted by the spring, the opens allowing process fluid to exit the until the fluid falls below the preset value. These can be preset to a specific or they may be adjustable. The New Surplus and Remanufactured division of Industrial consists of Safety/s, Manual s, Control s, and Actuators. We have a large inventory of Crosby, Consolidated, and Farris, High and Low Safety and Oil . The Industrial Manual and Actuator surplus inventory is second to none. With five acres covered and a 50,000 square foot warehouse filled with Gate, Globe, Check, Ball, Plug, and Butterfly s, we can alleviate virtually any situation a customer may encounter. We at Industrial have the largest selection of new surplus Limitorque Actuators with over 250 units ranging from the SMB-000 to the SMB-5T in stock and ready for delivery. All Safety/Relief, Manual, Control and Actuators are catalogued and inventoried on computer for quick verification and pricing to our customers.