SNYDER GENERAL DRAFT INDUCER MOTOR PARTS

Buy Snyder General Draft Inducer Motor Parts

The Snyder General Draft Inducer Motor is a constructive pressure blower that energizes and boosts when there is a need for heat. The Snyder General Motor blows air into the vent for about 30 seconds at the beginning of the heating process. This verifies that the outside vent is clear and will permit combustion gas to be drawn in. If the will not run, it will prevent the creation of a fire.

The Snyder General Motor induces correct air flow before the flame is lit. The makes sure heat problems will not occur and combustion gas will not escape the heating system. The Snyder General Motor starts before the flame is lit and continues running while the flame is burning. An ideal unit functions until the furnace senses it. If the motor is not detected, the furnace will shut down. This is the most common reason for a furnace malfunction.

The Snyder General Motor functions when the thermostat calls for heat. The motor starts and the pressure switch senses the negative pressure made by the Snyder General motor. The pressure switch is attached by a rubber tube or small tube. Once the pressure switch is blocked it will create problems for the motor. The Snyder General Motor runs for 30 to 60 seconds. The flame sensor now senses heat from the pilot and allows gas to flow to burner. The gas burner is ignited by the hot surface igniter or the intermittent pilot and these processes are controlled by the electronic control center module.

Most HVAC parts should be properly maintained and checked. It is best to have an technician check your system to make sure it is performing correctly. In the case of part replacement, make sure you get the best in the market. The Snyder General Motor is among the best in parts and provides certainty in good quality for your needs